Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateFast, Reliable Garage Door Installation Across Kent
If you’re pricing a new garage door in Kent, a typical installed replacement runs $700 – $2,200 depending on size, material and how much framing the opening needs. We handle the whole job: measuring the opening, matching the door to your house, and setting new springs, tracks and hardware so it runs right from day one. Kent mixes tight valley lots with big East Hill driveways, and the door that fits one rarely fits the other. Call (844) 443-4774 for a free on-site measure and a written price before anything is ordered.
Why Kent Homeowners Call Garage Door Repair South Hill for Garage Door Installation
We’re not a single-brand dealer pushing whatever sits in the catalog. Our technicians have up to 11 years of experience, and they work across the door and opener lines most Kent households already own, so the advice you get is about your opening, not a sales quota.
Installation days in Kent have their own logistics. Alley-load garages and shared driveways leave little room to swing a 16-foot door off a trailer, and some East Hill streets fill up fast with parked cars. We plan the delivery and staging around your access instead of assuming a wide open driveway. That planning is why we ask about alley width, overhead obstructions and where the old door will go before the truck ever leaves.
Every quote is free and written. The price is agreed before we order a door or touch a track, so the number on the estimate is the number you plan around. If you want to see how we approach the full scope of this work, our garage door installation page covers the process end to end.
Styles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
Our Garage Door Installation Services in Kent
New Door Installation
A full replacement is more than hanging a slab. In Kent’s older valley neighborhoods, the opening itself often needs squaring before a new door will seal, because decades of settling have pushed the frame slightly out of true. We check the jambs, header and floor line first, then set tracks and springs to the actual opening rather than the brochure dimensions.
Single Car Door
A single door in Kent typically runs $700 – $1,400 installed. These are the standard fit for the narrow one-car and compact two-car garages common in the postwar ranches on the valley floor, where a full-width double door simply won’t clear the posts. Getting the width and headroom measurement right matters here, since there’s no room to fudge a tight opening.
Double Car Door
Double doors run $1,200 – $2,200 installed and are where the East Hill tracts come in. The 1990s-2000s homes up toward 98042 often have wide three-car openings with a double door and a single beside it, and those bigger spans carry heavier panels that need the right torsion system, not the builder-grade parts that came with the house.
Custom Garage Door
Custom work runs $1,500 – $2,200 and covers odd openings, matched architectural styles, and the alley-load garages tucked into Kent’s denser subdivisions. If your opening is undersized, offset, or the surrounding structure is tight, a stock door won’t fit cleanly. We measure for a custom build and confirm clearances before ordering.
Trusted Brands We Service in Kent
We work with the brands you’re most likely to find on a Kent home: Clopay and Amarr for the door itself, and LiftMaster, Chamberlain and Genie on the opener side. Because we’re familiar with how each line is built, we can recommend a door and opener pairing that works together rather than forcing mismatched parts. We don’t claim to stock parts locally, and we won’t pretend a particular brand is the only right answer. What we do is order the door that suits your opening and set it up so the opener isn’t fighting springs that are too light for the panel weight.
See the difference
Before
After
Before
After
Before
AfterCommon Garage Door Installation Problems We See in Kent Homes
Kent’s two housing profiles fail in different ways, and the fix follows the neighborhood:
- Valley wood doors rotting at the bottom section. In the 1950s-70s ranches, the original wood sectional doors soak up rain at the threshold and the bottom panel soft-rots, which makes the door bind and the opener strain against a swollen section. Often the smart first move is a new bottom section and weather seal rather than a whole door.
- East Hill doors wearing out springs early. The 16-foot insulated steel doors on the newer tracts are heavier than the original spring cycle rating accounts for, so standard torsion springs wear out prematurely. An installation here usually means upgrading to high-cycle springs sized for the panel weight.
- Tight alley-load track misalignment. In the dense subdivisions, repeated bumping against the track knocks it out of line, and a misaligned track is how cables jump their drums and the door goes off balance. We reset alignment and check the drum seating as part of any installation.
- Damp-air sealing gaps. Puget Sound rain and valley fog find every gap, so a door that isn’t set flush lets moisture in around the frame. We verify balance and a flush close before the job is done.
Pricing for Garage Door Installation in Kent, WA
These are typical estimated ranges for Kent, not a firm quote. Your written estimate sets the final price after we’ve measured the opening and checked the framing.
| Service | Typical Estimated Range |
|---|---|
| New Door Installation | $700 – $2,200 |
| Single Car Door | $700 – $1,400 |
| Double Car Door | $1,200 – $2,200 |
| Custom Garage Door | $1,500 – $2,200 |
Material, size and insulation drive most of the cost, and so does framing repair on an older opening. If the old door has to come out and the frame needs work, that adds labor and materials. We put it all in writing before you commit. Call (844) 443-4774 for a free estimate.
We Also Serve Cities Near Kent
We also work in the towns around Kent, including Covington, Des Moines, Federal Way and Auburn. If you’re just over the line from one of Kent’s edges, the same installation process and the same written-estimate approach apply. Call and tell us where you are, and we’ll confirm the visit.
Serving Kent, WA – Our Local Coverage Area
We serve Kent and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs – Garage Door Installation in Kent
Because the bottom section sits closest to the wet ground and takes the brunt of Puget Sound rain, a straight like-for-like swap often just resets the clock. The real fix usually includes re-sealing the frame and threshold so water stops wicking into the new panel. When we measure a valley home, we check whether the opening drains and seals properly before recommending a door. Call (844) 443-4774 for a free look.
The spring has to be matched to the actual panel weight and door height, so there’s no single size that fits every East Hill double door. Builder-grade springs on the newer tracts are often rated for lighter cycles than a heavy insulated panel demands, which is why they wear out early. We weigh the door and size the torsion system to it, then confirm balance before we finish. Call for a free measure and estimate.
Yes, with planning. Alley-load and tight subdivision garages leave little clearance, so we measure the alley, overhead obstructions and side room first and stage the work to avoid the walls and posts. The door goes in without forcing the frame. Call (844) 443-4774 and describe the access so we can plan the visit.
If your current opener is older or underpowered for the heavier new panel, it will strain and shorten its own life, so replacing it alongside the door usually makes sense. If it’s a modern LiftMaster or Genie unit rated for the new door’s weight, it can often stay. We check the opener’s capacity against the new door before recommending anything. Call for a free assessment.
We install Clopay and Amarr doors and set them up with LiftMaster, Chamberlain or Genie openers as the job calls for. Our technicians work across those lines, so the recommendation follows your opening and panel weight rather than a single brand. We don’t stock parts locally, so each door is ordered to fit. Call (844) 443-4774 for a free estimate.
Ready to replace your door? Call (844) 443-4774 for a free estimate. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Written by the team at Garage Door Repair South Hill.